6
P68 Pellet Stove
The P68 is bolted (1/4 x 1" hex head bolts) to the skid
to prevent movement during shipping.
To free the stove from the skid you must remove the
hold-down bolts in the rear of the pedestal base.
The rear cover panels need removed from the stove to
make it easier to get at the hold-down bolts.
The rear cover panels must be reinstalled once the
installation is complete. These panels are to gaurd from
contact with hot and moving parts. To reduce the risk
of electric shock, disconnect power before removing
the rear covers.
Install the rebrick vertically on the angle bracket above
the burnpot.
Install the cast iron ame guide on top of the burn pot.
Make sure that the ame guide is fully seated on the
vertical sides of the burn pot and that the back of the
guide rests against the body of the stove.
Most pellet vent requires a minimum of 3" of clearance
to combustible materials.
Spring Washer
1. Remove wood handle, spring washer, and socket head cap screw ¼-20 x 2-1/4" from hardware pack.
2. Install spring washer and wood handle onto socket head cap screw as shown in g. 2 and thread onto latch
on front door.
3. Tighten using a 3/16" hex key wrench.
Wood Handle
1/4-20 x 2-1/4
socket- head screw
Fig. 2
Rear Cover
Panels
Shipping Bolts
Note: These same holes
are used for securing the
stove in mobile home
installation.
Fig. 1
To Next Page
Loading...
Need help?
General
