31
P68 Pellet Stove
Side heat shields are available to reduce the clearance
to combustible materials.
Part #1-00-06716
The Direct Vent Wall Pass-
through Kit (part #1-00-677077)
incorporates safe venting
passage through a wall, and
provides the conduit for outside
air in one component.
The decorative slate tiles measure 11.938" x 5.938".
The tile frame, which is part of the trim kit, is not
necessary to hold the tile in place on the stove. The tile
can be adhered to the recessed area of the ash door
using high temp silicone. There are 4 slate choices.
See dealer for samples.
The Brushed Stainless deer cutout, pictured below, is
another option available. This cutout reveals the color
of the stove through the cut out shapes.
On the rear of the stove hopper there is a
hole to fasten the hopper extension into place.
On some units, this hole will need to be
opened. You will notice a small uncut area on
rear of the knockout. Push downward with a
screwdriver or like tool until the knockout is
rotated as far back to the inside of the hopper
as possible. This will allow the swell latch of the
hopper extension to fully expand to the bottom
side of the hole for a proper seal.
5.938"
11.938"
frame tile/slate
Part #1-00-06717 Available in Gold, Nickel or Brushed
Stainless. Includes the door trim, ash door frame, and
the ash lip. (Decorative tile or slate not necessary)
To Next Page
Need help?
General
