Hayward AquaRite series User Manual

How To: Switch from Metric to US Standard
7
If the first reading (average salt) is displayed in decimal form instead of a number
represented in thousands, then the unit has been set to ‘Metric Mode’.
Step 3
Step 4
Step 1
3.20
To change the unit from Metric Mode to US Standard, start by
pressing the ‘Diagnostics’ button one time.
Immediately the temperature reading should change to reflect a
Fahrenheit value. If it does not repeat step 2.
After 30 seconds the unit should settle back to the default
reading. The reading should now reflect a number in thousands.
Once showing the temperature in Celsius, move the switch up to
‘Super Chlorinate’ then back to ‘Auto’.
30
86
3200
Step 2
NOTE: The process is the same to go from US Standard to Metric.

Hayward AquaRite series Specifications

General

Category	Salt Chlorination System
Salt Level	2700-3400 ppm
Voltage	120V/240V
Chlorine Output	1.45 lbs/day
Pool Size	40, 000 gallons
Flow Rate	20 GPM
Water Temperature Range	50°F - 100°F (10°C - 38°C)