HEIDENHAIN iTNC 530 143
4.7 List of All Current Error Messages
Window contents
Column Meaning
Number Error number (–1: no error number defined),
issued by HEIDENHAIN or your machine tool
builder
Class Error class. Defines how the TNC processes
this error.
îš„ ERROR
Collective error class for errors that can
cause various error reactions depending on
the condition of the machine or the active
operating mode)
îš„ FEED HOLD
The feed-rate release is canceled
îš„ PGM HOLD
The program run is interrupted (the control-
in-operation symbol blinks)
îš„ PGM ABORT
The program run is interrupted (INTERNAL
STOP)
îš„ EMERG. STOP
EMERGENCY STOP is set off
îš„ RESET
TNC executes a system restart
îš„ WARNING
Warning message, program run resumes
îš„ INFO
Info message, program run resumes
Group Group. Specifies from which section of the
operating system software the error message
was generated
îš„ OPERATING
îš„ PROGRAMMING
îš„ PLC
îš„ GENERAL
Error message Respective error text displayed by the TNC
To Next Page
Loading...
Need help?
General
