(7)Release the parking brake.
(8)Make trial of the mast for lifting, lowing and forward and backward tilting
and the truck for steering and braking.
(9)The contamination level of the hydraulic oil should be lower than 12 as
described in NAS 1638.
4. Operation of Forklift Truck
(1)Only trained and authorized operator shall be permitted to operate the truck.
(2)Wear all the safety guards, such as shoes, helmet, clothing and gloves while
operating the truck.
(3)Check all the control and warning devices before staring the truck. If any
damages or defects are found, operate it after repairing.
(4)The goods handled should not exceed the rated capacity of the truck. Insert
forks deeply under goods and make the loads distribute on the forks evenly. Don't pick
the loads with one fork tip.
(5)The starting, turning, driving, braking and stopping of the truck should be
done smoothly. When steering on the humid or low friction road, the truck should be
decelerated.
(6)Travel with loads as low as possible and tilted backward.
(7)Be careful when traveling on a slope. When climbing grade with a slope more
than 10%, the truck should travel forward, and when descending so grade, backward
travel. Never turn on a slope. Avoid loading and unloading operation when
descending.
(8)Pay attention to pedestrian, obstacle and bumpy road when driving. Pay
attention to the clearance over forklift truck.
(9)Never allow any person(s) to stand on the forks or the truck to carry person.
(10)Never permit anyone to stand or walk under upraised forks.
(11)Don't operate truck and attachment at any position out of the driver seat.
(12)On the high lift forklift truck with the lift more than 3m, it is noted that the
-2-
To Next Page
Loading...
Need help?
General
