goods on it should not fall down or the protection measures be taken if necessary.
(13) Tilt the mast of the high lift forklift truck as backward as possible when the
truck works. Use minimum forward and reverse tilt when loading and unloading.
(14)Be careful and slowly driving over a dockboard or bridge-plate.
(15)Shut down the engine and don't stay on the truck when filling fuel. Don't
ignite the engine when checking battery or fuel lever.
(16)The unloaded forklift truck with attachment(s) should be operated as a
loaded truck.
(17) Don't handle unfixed stacked goods. Be careful to balky goods to be
handled.
(18) When leaving lower the forks on the ground and let the shift lever to neutral,
shut down the engine or cut down electric supply. If parking on a grade is unavoidable
apply the parking brake and block the wheels.
(19) Don't open the radiator cap when the engine is warm.
(20) Don't adjust the control valve and relief valve at will to prevent the damage
of hydraulic system and its components because of excessive pressure passing them.
(21) Tyres should be inflated according to the pressure valve specified in the
mark plate of “Tyre pressure”.
(22) According to the measure method specified in JB/T 3300. Max. noise at the
outboard of the truck should be not more than 89dB(A).
5. Cautions on Cooling System
Cooling system which is filled with HELI exclusive coolant free from
maintenance normally before leaving the factory is used to cool engine and hydraulic
powered transmission unit (hydraulic powered type forklift truck). The coolant filled
in the truck can not only protect the truck against freezing above -35℃, but also
protect the cooling system from corrosion, scale-forming and increase the coolant
boiling point remarkable. So the coolant concentration will not be reduced even in the
warm season or area because of water replenishing. If greater anti-freezing protection
-3-
To Next Page
Loading...
Need help?
General
