7. Press STOP BUTTON to stop playing.
8. To turn off the CD player, slide the FUNCTION SELECTOR to “OFF”. The LED DISPLAY
and POWER INDICATOR will go off.
Note: Never open the CD DOOR when a CD is playing to avoid possible exposure to laser
radiation.
REPEAT MODE
Repeat 1
When the REPEAT BUTTON is pressed once, the REPEAT INDICATOR will light and blink
continuously. The current track will be repeated until it is interrupted.
Repeat All
When the REPEAT BUTTON is pressed twice, the REPEAT INDICATOR will light steadily. The
whole disc will be played continuously.
To Cancel the Repeat Function: Press the REPEAT BUTTON until the repeat indicator goes
off.
SKIP AND SEARCH MODE
1. During Play or Pause mode, tap the NEXT or BACK BUTTON to go to the next track or go
back to the beginning of the current track.
2. During Play mode or Pause mode, press and hold the NEXT/ or BACK/ BUTTON to
search within the current track with audible high speed playback.
PROGRAM PLAY MODE
This function allows music tracks to be played in a programmed sequence.
Note: Program can only be set in STOP mode.
1. Press the PROGRAM BUTTON once. Both Program Number “01” and the PROGRAM
(PROG) INDICATOR will flash.
2. Press the NEXT or BACK BUTTON to select the track to be programmed.
3. Press the PROGRAM BUTTON again to store the selection. The Program Number will
advance to “02” and flash to prompt for the next input.
4. You may repeat steps #2 to #3
to program up to 20 tracks. As soon as you have entered the
20th track, the LED DISPLAY will automatically show the programmed tracks one by one in
their correct sequence starting from the first. At the end of program review, Program Number
“01” and the PROGRAM INDICATOR will both flash.
5. Press the PLAY BUTTON to complete and start program play. Otherwise, press the STOP
BUTTON to complete and exit program mode.
6. To review/edit the programmed tracks during play, press the STOP BUTTON and then the
PROGRAM BUTTON, the LED DISPLAY will show Program Number “01” and the
PROGRAM INDICATOR will both flash. If you do not want to change any track in the
program, press PLAY BUTTON or wait about 30 seconds to exit edit mode automatically.
7. To edit a programmed track, first press the PROGRAM BUTTON until you reach the
program number whose track you want to change then press the NEXT or BACK BUTTON
to select a new track and press PROGRAM BUTTON again to confirm.
8. To cancel program play, press the STOP BUTTON twice while reviewing programmed tracks
or open the CD DOOR in STOP mode.
9. To turn off the CD player, slide the FUNCTION SELECTOR to “OFF”. The LED DISPLAY and
POWER INDICATOR will go off.
To Next Page
Loading...
Need help?
General
