2
4-Pin Din Connetor Interface
Interfaces of 4-Pin Din Connector
The power supply for the camera is 6 VDC to 16 VDC.
2 Installation
Before you start:
� Please make sure that the device in the package is in
good condition and all the assembly parts are
included.
� Make sure that all the related equipment is power-off
during the installation.
� Check the specification of the products for the
installation environment.
� Check whether the power supply is matched with your
power output to avoid damage.
� Be sure that there is enough space to install the
camera and accessories.
� Make sure the part, which is used to install the camera,
is strong enough to withstand four times the weight of
the camera and the mounting.
� If the product does not function properly, please
contact your dealer or the nearest service center. Do
not disassemble the camera for repair or maintenance
by yourself.
� Do not pull and drag the camera cables hard.
Steps:
To Next Page
Loading...
Need help?
General
