EasyManuals Logo
Home>HIKVISION>Control Panel>AXHub

HIKVISION AXHub User Manual

HIKVISION AXHub
90 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
Note
Ehome5.0: a privacy internet protocol that is used for accessing
the third-party plaorm, which supports alarm report uploading,
security control panel management, and short video uploading.
Note
Standard DC-09 Protocol
ADM-CID: The data presenng method of DC-09 is CID, which is
not encrypted and only for uploading alarm report.
*ADC-CID: The data presenng method of DC-09 is CID, which is
encrypted and only for uploading alarm report.
SIA-DCS: The data presenng method of DC-09 is DCS (also called
SIA protocol), which is not encrypted and only for uploading
alarm report.
*SIA-DCS: The data presenng method of DC-09 is DCS (also
called SIA protocol), which is encrypted and only for uploading
alarm report.
1.3 ATS Category
Table 1-2 ATS Category
Category Model
DP2
DS-PWA32-HSR
DS-PWA32-HS
DS-PWA32-HGR
DS-PWA32-HG
SP4
DS-PWA32-HR
DS-PWA32-H
Note
If the ATP fault is detected, the control panel will generate and
report logs. If the ATS fault is detected, the control panel will
generate and report logs, indicates the fault with Alert LED (solid
orange), and prompts fault details when the system is disarmed
by authorized users.
DP2: While the alarm receiving center is enabled. The control
panel will upload alarm report to the receiver center via the main
path (LAN or Wi-Fi) or the back-up path (3G/4G). If the control
panel is properly connected to the LAN or Wi-Fi, the main path is
selected as the transmission path. If the main path
connecon is
failed, the path will be switched to 3G/4G. And if the main path
connecon is restored, the path will be switched back to LAN or
Wi-Fi. The control panel checks the connecon status
connuously, and generates logs transmission fault for any of the
path. While both of the paths are invalid, the control panel
determines ATS fault.
SP: Control panel can only upload report via LAN or Wi-Fi. While
the
connecon is failed, the control panel determines ATS fault
and stores the event log.
You can check the fault informaon in the control panel logs.
4

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HIKVISION AXHub and is the answer not in the manual?

HIKVISION AXHub Specifications

General IconGeneral
BrandHIKVISION
ModelAXHub
CategoryControl Panel
LanguageEnglish

Related product manuals