Figure 3-11 PTZ Configuration
Auto-flip
In manual tracking mode, when a target object goes directly beneath the speed dome, the speed
dome automatically rotates 180 degrees horizontally for tracking.
You can set AUTO FLIP as ON or OFF to enable/disable the function.
AUTO-FLIP is set as ON for this speed dome by default and it’s not user-definable.
Proportional Panning
When the speed dome is zooming in/out, you can enable the proportional panning function to
automatically reduce or increase the panning and tilting speed according to the zooming amount.
This function enables the speed dome to trace the object at a proper speed when the speed dome
is zooming and the monitored scene is narrowed (zoom in) or enlarged (zoom out).
You can set PROPORTIONAL PAN as ON or OFF to enable/disable the function.
This function is enabled automatically while setting the patterns.
Park time and actions
Purpose:
This feature allows the speed dome to start a predefined action (park action: scan, preset, pattern,
etc.) automatically after a period of inactivity (park time).
You can set PARK TIME from 5 to 720 seconds and set the park action (PARK ACT) as preset 1-8,
pattern 1-5, patrol 1-10, pan scan, tilt scan, random scan, frame scan, panoramic scan, day mode,
night mode or none.
If no control signal is received after the park time under the following circumstances, no park
actions will be performed: in the process of performing dome actions by calling special presets;
or in the process of performing external alarm linkage actions.
Preset freezing
To Next Page
Loading...
Need help?
General
Weight and Dimensions
