SHARPNESS
Sharpness determines the amount of detail an imaging
system can reproduce. You can set the SHARPNESS
value from 1 to 9.
SATURATION
Adjust this feature to change the saturation of the color.
The value ranges from 1 to 9.
DNR (Digital Noise Reduction)
The DNR function can decrease the noise effect,
especially when capturing moving images in poor light
conditions, and delivering more accurate and sharper
image. You can set the DNR value from 1 to 9.
MIRROR
OFF, H, V, and HV are selectable for mirror.
OFF: The mirror function is disabled.
H: The image flips 180° horizontally.
V: The image flips 180° vertically.
HV: The image flips 180° both horizontally and
vertically.
3.5 FUNCTIONS
WHITE LIGHT
In the WHITE LIGHT mode, you can set the mode as
AUTO or OFF.
ALARM MODE
In the ALARM MODE, you can select the ALARM MODE
as SOLID, or FLASHING.
Figure 3-6 FUNCTIONS
SOLID
Select the ALARM MODE as SOLID. In this way, the
white light source turns on, when the PIR module
received the alarm signal.
FLASHING
Select the ALARM MODE as FLASHING. In this way, the
white light source flashes when the PIR module
received the alarm signal.
Note:
When the WHITE LIGHT is selected as AUTO, you can
only select the ALARM MODE as FLASHING.
TIME SETTINGS
In the TIME SETTINGS you can set the time as 5 s, 10 s,
15 s, 30 s, or 60 s, which means that the solid mode
stays for the set time when the camera received one
alarm signal.
Note:
The solid mode will be stayed for another set time
when second alarm signal is received, and the rest can
be done in the same way.
PIR LEVEL
Adjust the sensitivity of the PIR module, and the higher
the value is, the more sensitive the PIR module is.
To Next Page
Loading...
Need help?
General
