Figure 2-10 Secure Junction Box Body
6. Route the cables through the bottom cable hole or
the side cable hole of the junction box.
7. Combine the junction box cover with its body and
secure it with three PM3 × 13 screws.
Figure 2-11 Combine Junction Box Cover and Body
8. Fix the base onto the junction box cover with three
M4 × 10 screws.
Figure 2-12 Fix Base
9. Connect the power cord and video cable and put
the cables back into the junction box.
10. Repeat the steps 6, 8, and 9 of 2.2.1 Ceiling
Mounting Without Junction Box to finish the
installation.
Figure 2-13 Finish Installation
2.2.3 Wall Mounting
Before you start:
You need to purchase a wall mount in advance.
Steps:
1. Drill Ø 10 mm screw holes in the wall where you
want to install the wall mount.
2. Use four M6 expansion bolts to fix the wall mount
onto the wall.
To Next Page
Loading...
Need help?
General
