Thermal & Optical Bi-spectrum Network Camera User Manual
70
IP addresses in the list cannot access the device.
Only IP addresses in the list can access the device.
4. Edit the IP address filter list.
Add a new IP address to the list.
Modify the selected IP address in the list.
Delete the selected IP address in the list.
5. Click Save.
12.13.4 Set SSH
SSH is a protocol to ensure security of remote login. This setting is reserved for professional
maintenance personnel only.
Steps
1. Go to Configuration → System → Security → Security Service.
2. Check Enable SSH.
3. Click Save.
12.13.5 Set HTTPS
HTTPS is a network protocol that enables encrypted transmission and identity authentication,
which improves the security of remote access.
Steps
1. Go to Configuration → Network → Advanced Settings → HTTPS.
2. Check Enable.
3. Click Delete to recreate and install certificate.
Create and install
self-signed certificate
Refer to Create and Install Self-signed Certificate
Create certificate
request and install
certificate
Refer to Install Authorized Certificate
To Next Page
Loading...
Need help?
General
