HIKVISION DS-3E0108P-E User Manual

Unmanaged PoE Switch/User Manual
3
LED
State
Description
Power
Solid on
The switch is connected to a power supply properly.
Off
The switch is not connected to a power supply properly or not
connected to a power supply.
PoE Max
*Available only
on
DS-3E0108P-E
Solid on
The PoE power output reaches the alarm threshold, and the powered
device is powered properly.
Blinking
The PoE power output reaches the maximum power, and some of
power devices are not powered properly.
Off
The PoE power output does NOT reach the alarm threshold, and the
powered device is powered properly.
PoE Status
Solid on
The port is connected to a powered device and is supplying power.
Blinking
The PoE output of the port exceeds 40 W.
Off
The port is not supplying power or not connected to a powered
device.
Link/Act
Solid on
The port is connected properly.
Blinking
The port is transmitting data.
Off
The port is not connected properly or not connected to a device.
100 Mbps
*Available only
on
DS-3E0109P-E/M
Solid on
The transmission rate of this port is 100 Mbps.
Off
The transmission rate of this port is 10 Mbps when the LINK/ACT
LED of corresponding port lights up.
The port is not connected to a device when the LINK/ACT LED of
corresponding port is off.
Rear Panel
DS-3E0108P-E
PoE Ports
RJ45 Ports
Power Jack

HIKVISION DS-3E0108P-E Specifications

General

Brand	HIKVISION
Model	DS-3E0108P-E
Category	Switch
Language	English