HIKVISION DS-3E0109P-E User Manual

User Manual of Network Video Recorder DS-3E0109P-E
16
Chapter 3 Physical Connection
3.1 Connect to RJ45 Ports
Connect the switch to a remote device with Ethernet cable via RJ45 port. UPLINK is the uplink port. Ports 1-4/8
support IEEE 802.3af and IEEE 802.3at PoE supply, and the PD can be wireless AP, IP phone or IP camera, etc.
Figure 3.1 RJ45 port connection
Note that:
 Cat.5e or better Ethernet cable is recommended. As each RJ45 port supports MDI/MDIX auto-negotiating,
either parallel or crossover cable is available.
 The device supports dynamic PoE supply. Namely, the device will power the PD properly and automatically.
3.2 Check the Cabling
Once installation is completed, check the cabling of the device as the following:
 The operating power supply should accord with rated input standard.
 Ports cablings and grounding cable are correctly connected.
 If there is outdoor cabling, connect a lightning protector to the cable before you plug the cable into the port.

HIKVISION DS-3E0109P-E Specifications

General

Brand	HIKVISION
Model	DS-3E0109P-E
Category	Switch
Language	English