HIKVISION DS-3E03 P Series User Manual

Installation Manual of DS-3E2300P Series Ethernet Switch
[选取日期]
- 13 -
Table 3-2 Definition of the pins of the 1000M RJ45 port
No.
Item
Description
1
TXD1+
Sending the normal phase of the data
2
TXD1-
Sending the paraphase of the data
3
RXD1+
Receiving the normal phase of the data
4
TXD2+
Sending the normal phase of the data
5
TXD2-
Sending the paraphase of the data
6
RXD1-
Receiving the paraphase of the data
7
RXD2+
Receiving the paraphase of the data
8
RXD1-
Sending the paraphase of the data
The direct-through or cross network cable has the function of auto-identification, so the five
classes of direct-through/cross network cables can be used to connect other Ethernet devices.
3.4 Checkup after Installation
Before feeding power to start the switch, perform the following checkups after the switch is
installed:
 If the switch is installed on the DIN rail, check whether the installation is strong. If the switch is
installed on the desk, check whether there is enough space for the switch to discharge its heat
and whether the desk is stable.
 Check whether the connected power supply meets the power requirements of the switch.
 Check whether the grounding line of DS-3E2300P is correctly connected.
 Check whether DS-3E2300P is correctly connected to other terminal devices.

HIKVISION DS-3E03 P Series Specifications

General

Brand	HIKVISION
Model	DS-3E03 P Series
Category	Switch
Language	English