HIKVISION DS-3E1318P-EI User Manual

DS-3E1xxxP Series 100 Mbps PoE Switches Quick Start Guide
QSG DS-3E1xxxP Switch 012721NA 13
5 Powering on the Device
Use the power cord in the package to power on the device.
Before powering your switch, make sure that:
• The operating power supply is compliant with rated input standard.
• Port cables and grounding cables are correctly connected.
• If there is outdoor cabling, connect a lightning rod and lightning arrester to the cable.
CAUTION
PoE power supply line and strong wire cannot be wired together, otherwise PD equipment or switch ports
will be burnt.
6 Device Management
The device can be configured and managed through iVMS-4200 software, mainly including network
parameter configuration, port configuration, link aggregation configuration, network topology display,
and so on.
This chapter will briefly introduce the device management through the iVMS-4200
software. For other functions, please refer to iVMS-4200 Client Software User Manual .
All pictures in this manual are for illustration only, and the specific interface is
subject to the actual interface.
6.1 Activating Devices
You are required to create a password to activate inactive devices before they can be added to the
software and work properly.
Before You Start
Make sure the device to be activated is connected to the network and is in the same subnet as the PC
running the client.
Steps
This function should be supported by the device.
1. Enter the Device Management page.
2. Click Device tab on the top of the right panel.
3. Click Online Device to show the online device area at the bottom of the page.
The searched online devices are displayed in the list.
4. Check the device status (shown on Security Level column) and select an inactive device.

HIKVISION DS-3E1318P-EI Specifications

General

Switch type	-
Product color	Blue
Housing material	Metal
Input current	2.5 A
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (max)	250 W
Total Power over Ethernet (PoE) budget	230 W
Power over Ethernet (PoE) ports quantity	16
Power over Ethernet (PoE) power per port	30 W
Storage temperature (T-T)	-40 - 85 °C
Operating temperature (T-T)	-10 - 55 °C
Operating relative humidity (H-H)	5 - 95 %
10G support	No
Networking standards	IEEE 802.3, IEEE 802.3ab, IEEE 802.3af, IEEE 802.3at, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z
Combo SFP ports quantity	2
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports type	Fast Ethernet (10/100)
Forwarding rate	5.3568 Mpps
MAC address table	16000 entries

Weight and Dimensions

Depth	220.8 mm
Width	440 mm
Height	44 mm
Weight	2590 g