HIKVISION DS-7100NI-Q1/P Series - Other Events; Configure Arming Schedule

4. Oponal: Check Save VCA Picture to save the captured pictures of VCA detecon.
5. Set the detecon rules and detecon areas.
1) Set Arming Area. Up to 4 arming areas are selectable.
2) Adjust
Sensivity. Sensivity: Range [0-100]. The higher the value is, the more easily the
detecon alarm can be triggered.
3)
Oponal: Set Target Detecon as Human or Vehicle to discard alarms which are not triggered
by human body or vehicle.
Note
This funcon is only available for certain models.
4) Click Draw Area and draw a quadrilateral in the preview window by specifying four vertexes of
the
detecon region.
6. Set the arming schedule. Refer to Congure Arming Schedule for details.
7. Set the linkage acons. Refer to Congure Alarm Linkage Acon for details.
8. Click Apply.
6.4.3 Other Events
Thermal Camera Detecon
The device supports the event detecon modes of thermal network cameras: re detecon,
temperature detecon, etc. You can congure the arming schedule and linkage acons of the
selected event.
Before You Start
Add a thermal network camera to your device and make sure the camera is
acvated.
Steps
1. Go to
Conguraon → Event → Other Events .
2. Select a thermal camera detecon event.
3. Set Camera.
4. Set the arming schedule. Refer to
Congure Arming Schedule for details.
5. Set the linkage
acons. Refer to Congure Alarm Linkage Acon for details.
6. Click Apply.
6.4.4
Congure Arming Schedule
Steps
1. Click Arming Schedule.
2. Choose one day of a week and set the
me segment. Up to eight me periods can be set within
each day.
Network Video Recorder User Manual
62