User Manual of Network Video Recorder
135
9.2 Configuring Advanced Settings
9.2.1 Configuring EZVIZ Cloud P2P
Purpose:
EZVIZ Cloud P2P provides the mobile phone application and as well the service platform page to access and
manage your connected NVR, which enables you to get a convenient remote access to the surveillance system.
If PPPoE function is disabled, enabling the EZVIZ cloud P2P will lead the UPnP function to be enabled.
Among EZVIZ cloud P2P and DDNS, only one can be enabled.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the Platform Access tab to enter the EZVIZ Cloud P2P Settings interface.
3. Check the Enable EZVIZ Cloud P2P checkbox to activate this feature.
4. If required, select the checkbox of Custom and input the Server Address.
The default server address is dev.ezviz7.com.
5. To turn the Enable Stream Encryption on, you can select its checkbox.
6. Enter the verification code of the device.
The verification code consists of 6 capital letters and is located at the bottom of the DVR. You can also use the
scanning tool of your phone to quickly get the code by scanning the QR code below.
Figure 9. 2 EZVIZ Cloud P2P Settings Interface
7. Click the Apply button to save and exit the interface.
After configuration, you can access and manage the NVR by your mobile phone on which the EZVIZ Cloud P2P
application is installed or by the EZVIZ website (www.ezviz7.com).
For more operation instructions, please refer to the help file on the EZVIZ official website (www.ezviz7.com).
To Next Page
Loading...
Need help?
General
