Quick Operation Guide of DS-7200-SH/SV/SL and DS-7300/8100-SH Series DVR
11
DS-8132HCI-SH, DS-8132HFSI-SH and DS-8132HWSI-SH:
Note: The rear panel of DS-8124HCI-SH/DS-8124HFSI-SH/DS-8124HWSI-SH provides 24 video input
interfaces.
Table 8 Description of Rear Panel
1 VIDEO IN BNC connector for analog video input.
BNC connector for video output.
BNC connector for spot video output.
RCA connector for audio output. This connector is synchronized with
RCA connector for audio output. This connector is synchronized with
4 LINE IN RCA connector for two-way audio input.
5 AUDIO IN (1-4) RCA connector for audio input.
6 AUDIO IN (5-16) DB26 connector for audio input.
7 VGA DB15 connector for VGA output. Display local video output and menu.
8 RS-232 Connector for RS-232 devices.
9 HDMI HDMI video output.
Connects USB mouse or USB flash memory devices.
11 LAN1/LAN2 Interface 2 RJ45 10M / 100M / 1000M Ethernet interfaces.
12 eSATA Connects external SATA HDD, DVD-R/W.
RS-485 termination switch. Up position is not terminated.
Down is terminated with 120Ω resistance.
RS-485 Interface Connector for RS-485 devices. Connect the T+ and T- terminals to the R+
and R- terminals of PTZ receiver respectively.
KB Connect the D+ and D- terminals to Ta and Tb terminals of the controller.
For cascading devices, the first DVR’s D+ and D- terminals should be
connected with the D+ and D- terminals of the next DVR.
15 Alarm In/Out Connector for alarm input/output.
GND Ground(needs to be connected when DVR starts up)
17 100~240VAC 100~240VAC power supply.
18 POWER Switch for turning on/off the device.
To Next Page
Loading...
Need help?
General