HIKVISION DS-K1102M Installation Manual

11
No.
Description
DIP
Switch Status
7
Wiegand Protocol
(available when No. 6 is 1)
1: Wiegand protocol
of 26-bit;
0: Wiegand protocol
of 34-bit.
8
Matched Resistance
(available for RS
-
485 protocol)
1: Enable;
0
:
Disable.
3.3 Definition of Cable
The description of 10 cables is shown below.
Table 3-3 Description of Cable
Color
Description
Yellow RS-485+
Brown
Blue LED Control (
ava
ilable for
Wiegand
Protocol)
Blue RS-485-
Purple
Beep Control (
available for
Wiegand
Protocol
)
Gray Case Sensor (available for Wiegand Protocol)
Green
Wiegand W0 (
available for
Wiegand
Protocol
)
White Wiegand W1 (available for Wiegand Protocol)
Black
GND
Orange Red LED Control (available for Wiegand Protocol)
Red PWR (DC +12V)
3.4 Wiring Cables
Purpose:
Wire the cables between controller and card reader, thus to
establish the communication between them.
Steps for RS-485 communication mode:

HIKVISION DS-K1102M Specifications

General

Internal	No
Certification	IP64 CE, FCC
Product color	Black
LED indicators	Power, Status
Housing material	Acrylonitrile butadiene styrene (ABS)
Compatible memory cards	-
Input voltage	12 V
Output current	500 mA
Power source type	DC
Power consumption (max)	2 W
Operating temperature (T-T)	-20 - 65 °C
Operating relative humidity (H-H)	10 - 90 %
Interface	RS485 / Wiegand
Supported protocols	Mifare
USB 3.2 Gen 1 (3.1 Gen 1) ports quantity	0
Built-in processor	Yes
International Protection (IP) code	IP64
Frequency	13.56 MHz
Maximum read range	50 mm

Weight and Dimensions

Depth	121 mm
Width	86.5 mm
Height	14 mm
Weight	140 g