HIKVISION DS-KABH6320-T User Manual

●
When the zone type is set to be 24H Alarm, the indoor staon will receive alarm message
when the detector is triggered no maer it is under arming mode or disarming mode.
●
When the zone type is set to be Delay Alarm, only under arming mode, the indoor staon will
receive alarm message when the detector is triggered. Under disarming mode, it will not
receive alarm message when the detector is triggered.
●
Aer seng enter delay me, if OK is pressed within the enter delay me aer the alarm, the
alarm event will not be uploaded to the management center; if OK is not pressed within the
enter delay me aer the alarm, the alarm event will be uploaded to the management center.
●
The exit delay is the me between you enable the arming mode and the arming takes eect.
Network Camera Informaon
You can add, delete and edit cameras that can be added to the video intercom products, with two
ways of geng stream: direct or URL. By exporng and imporng the added device informaon,
you can edit added devices parameters in batch.
Add Camera
Steps
1.
Click IP Camera Informaon to enter IP camera informaon page.
Figure 4-12 IP Camera
Informaon
2.
Click Add to pop up the device adding dialog box.
3.
Enter corresponding informaon (device name, IP address, port No., user name, password, etc.),
and click OK.
Note
Indoor extension does not support this funcon.
Export and Import Added Device Informaon
Steps
1.
Click Export to export the added device informaon le.
2.
Edit parameters of added devices in batch in the exported le.
3.
Click Import to pop up imporng box, and open the edited added device informaon le.
Network Indoor Staon Conguraon Guide
54

HIKVISION DS-KABH6320-T Specifications

General

Brand	HIKVISION
Model	DS-KABH6320-T
Category	Intercom System
Language	English