EasyManuals Logo
Home>HIKVISION>Intercom System>DS-KIS703-P

HIKVISION DS-KIS703-P User Manual

HIKVISION DS-KIS703-P
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Safety Instrucon
Warning
The working temperature of the device is from -10 ºC to 55 ºC.
All the electronic operaon should be strictly compliance with the electrical
safety regulaons, re prevenon regulaons and other related regulaons in
your local region.
Please use the power adapter, which is provided by normal company. The power
consumpon cannot be less than the required value.
Do not connect several devices to one power adapter as adapter overload may
cause over-heat or re hazard.
Please make sure that the power has been disconnected before you wire, install
or dismantle the device.
When the product is installed on wall or ceiling, the device shall be rmly xed.
If smoke, odors or noise rise from the device, turn
o the power at once and
unplug the power cable, and then please contact the service center.
If the product does not work properly, please contact your dealer or the nearest
service center. Never aempt to disassemble the device yourself. (We shall not
assume any responsibility for problems caused by unauthorized repair or
maintenance.)
Cauon
Do not drop the device or subject it to physical shock, and do not expose it to
high electromagnesm radiaon. Avoid the equipment installaon on vibraons
surface or places subject to shock (ignorance can cause equipment damage).
Do not place the device in extremely hot (refer to the specicaon of the device
for the detailed
operang temperature), cold, dusty or damp locaons, and do
not expose it to high electromagnec radiaon.
The device cover for indoor use shall be kept from rain and moisture.
Exposing the equipment to direct sun light, low
venlaon or heat source such
as heater or radiator is forbidden (ignorance can cause
re danger).
Do not aim the device at the sun or extra bright places. A blooming or smear
may occur otherwise (which is not a
malfuncon however), and aecng the
endurance of sensor at the same me.
Video Intercom Two-Wire Villa Door
Staon User Manual
iv

Other manuals for HIKVISION DS-KIS703-P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HIKVISION DS-KIS703-P and is the answer not in the manual?

HIKVISION DS-KIS703-P Specifications

General IconGeneral
ColorYes
Relay inputs2
Video codecsH.264
Connectivity technologyWired & Wireless
Number of displays supported-
Voice codecsG.711a, G.711u
Megapixel2 MP
Maximum frame rate30 fps
Supported video modes720p, 1080p
Viewing angle, vertical95 °
Maximum video resolution1920 x 1080 pixels
Viewing angle, horizontal144 °
Power consumption (typical)10 W
Operating voltage (door opener)24 V
Operating relative humidity (H-H)10 - 95 %
Door station operating temperature (T-T)-40 - 60 °C
Main monitor station operating temperature (T-T)-10 - 55 °C
Display diagonal7 \
Touchscreen typeCapacitive
Display resolution1024 x 600 pixels
Display technologyTFT
Operating system installedLinux
Product colorSilver
International Protection (IP) codeIP65
Wi-Fi standards802.11b, 802.11g, Wi-Fi 4 (802.11n)
Cabling technology10/100Base-T(X)
Ethernet LAN data rates10, 100 Mbit/s
Ethernet interface typeFast Ethernet
Supported network protocolsTCP/IP, RSTP
Weight and Dimensions IconWeight and Dimensions
Depth140 mm
Width200 mm
Height23.6 mm
Weight334.5 g
Door station dimensions (WxDxH)169 x 110 x 31 mm

Related product manuals