HIKVISION DS-PHA64-W4M User Manual

Figure 4-44 Add User
4. Select User Type. Enter User Name and Password.
5. Enter Keypad Password.
Note
The keypad password +1 or -1 is the duress code. Use the duress code can operate the keyboard
to arm and disarm normally and upload a duress alarm. For example, if the keypad password is
123456, the duress code is 123455 or 123457.
6. Tap Add to add the user.
7. Oponal: Tap a user to edit the parameters. You can choose to enable the user or not. Select
the linked area and the permission.
8.
Oponal: Tap a user and tap Delete to delete the user.
Note
Admin, installer and mabufacturer can not be deleted.
4.3.8 System Sengs
System Opon
On the device list page, tap the security control panel and then log in to the device (if required) to
enter the control panel page.
Tap
→ System Opon to set parameters.
For
Opon Management:
Hybrid Security Control Panel User Manual
69

HIKVISION DS-PHA64-W4M Specifications

General

Brand	HIKVISION
Model	DS-PHA64-W4M
Category	Control Panel
Language	English