E Series IR Speed Dome Installation Manual
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
3.1.2 Wall Mounting
Steps:
1. Drill 4 screw holes in the wall according to the holes of the mount, and then insert M6
expansion screws (not supplied) into the mounting holes.
2. Attach the gasket then wall mount to the wall by aligning the 4 screw holes of the mount with
expansion screws on the wall.
3. Secure the wall mount with 4 hex nuts and washers.
Figure 3-3 Drill Screw Holes
4. Install the speed dome to the mount. Please refer to Section 1.1 Installing the IR Speed Dome
for installation details.
Figure 3-4 Finish the Installation
To Next Page
Loading...
Need help?
General
