Figure 2-14 Put the Trim Ring Back and Tighten It
6. Connect the corresponding cables, such as power
cord, and video cable.
7. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
Figure 2-15 3-axis Adjustment
2.4 Installation of Type V and Type VI Camera
Before you start:
Type V and Type VI cameras share the same installation,
and we take Type VI camera as the example to describe
the installation method.
Both wall mounting and ceiling mounting are suitable
for the camera. Ceiling mounting will be taken as an
example in this section. You can take the steps of ceiling
mounting as a reference, when adopting wall mounting.
Steps:
1. Paste the drill template (supplied) to the place
where you want to install the camera.
2. Drill the screw holes and the cable hole (optional) in
the ceiling according to the drill template.
To Next Page
Loading...
Need help?
General
