HIKVISION iDS-2CD7046G0-AP User Manual

iDS-2CD7xxG0-xxxxx Network Bullet Camera User Manual
UM iDS-2CD7xxG0-xxxxx 021021NA 42
Figure 6-3 Set Video Tampering Area
5. Refer to Set Arming Schedule for setting scheduled time. Refer to Linkage Method Settings for setting
linkage method.
6. Click Save.
Set PIR Alarm
A PIR (Passive Infrared) alarm is triggered when an intruder moves within the detector’s field of view. The
heat energy dissipated by a person or any other warm blooded creature such as a dog, cat, etc. can be
detected.
Steps
Only certain models support PIR alarm.
1. Go to Configuration → Advanced Configuration → Basic Event → PIR Alarm.
2. Check Enable PIR Alarm.
3. Refer to Set Arming Schedule for setting scheduled time. Refer to Linkage Method Settings for setting
linkage method.
4. Click Save.
Set Exception Alarm
Exceptions such as network disconnection can trigger the device to take corresponding action.
Steps

HIKVISION iDS-2CD7046G0-AP Specifications

General

Brand	HIKVISION
Model	iDS-2CD7046G0-AP
Category	Security Camera
Language	English