Figure 2-3 Remove the Bubble
3) Install the memory card (optional). Insert the memory card to the memory card
slot.
Note:
The memory card can be installed in factory if you need.
4) Reinstall the bubble and tighten the lock screws.
3. Install the speed dome to the bracket.
1) Hang the safety rope to the speed dome and the hook on the bracket.
2) Route the cables of the speed dome through the bracket body, and connect the
corresponding cables.
Note:
Water-proof treatment is required for cable connectors. Refer to Section 2.5 and
2.6 for details.
3) Loosen the two lock screws on the bracket.
4) Align the speed dome with the bracket as shown in Figure 2-4, and rotate the
speed dome clockwise tightly.
Figure 2-4 Install the Speed Dome
To Next Page
Loading...
Need help?
General
