2 Installation
Before you start:
● Make sure the device in the package is in good condition and all
the assembly parts are included.
● The standard power supply is 12 VDC or 24 VAC or PoE, please
make sure your power supply matches with your camera.
● Make sure all the related equipment is power-off during the
installation.
● Check the specification of the products for the installation
environment.
● Make sure that the wall is strong enough to withstand four
times the weight of the camera and the bracket.
For the camera that supports IR, you are required to pay attention to
the following precautions to prevent IR reflection:
● Make sure that there is no reflective surface too close to the
camera lens. The IR light from the camera may reflect back into
the lens causing reflection.
2.1 Memory Card Installation
Only certain camera models support memory card installation. The
actual device appearance may vary with the model. The following
takes a model as an example to illustrate the installation steps.
Steps:
1. Insert the memory card to memory card slot on the rear panel of
the camera.
To Next Page
Loading...
Need help?
General
