4
Getting started
Step 1. Attach stand or mount
Before you start using your TV, attach your TV stand or mount it on the wall.
CAUTION:
• Disconnect the A/C power cord before installing a stand or a wall mount bracket.
• The LED display on your TV is fragile. Make sure the TV screen is not scratched or
damaged by hard objects or from pressure.
• After the installation is complete, make sure the TV is steady on a table or firmly
attached to a wall mount, before removing all protective film, if any.
Attach the TV stand
Follow the illustrations and instructions below to complete the installation steps:
1. Carefully place your TV face down on a soft, flat surface to prevent damage to the
TV or scratching to the screen.
2. Remove the 2 stands from the accessory bag and then insert the stands into the
bottom slots of the TV.
3. Use the screws in the accessory bag to secure the base stand to the TV.
Screws: ST4 x 14F(32”)
M4 x 25 (40”)
BASE STAND
BASE STAND
Screws: ST4 x 14F(32”
M4 x 25 (40”)
To Next Page
Loading...
Need help?
General
