4
Accessories
First time use
Check to make sure you have the following accessories before disposing of the packing material.
/
Power Cord
Remote Control
Two “AA” size,
1.5V batteries
2 IR Blaster Cables
Table Top Stand
For U.S. models:
For optional accessories, please access our web site at:
www.hitachi.us/tv
Power Swivel Cable
1 Ferrite Core
(see page 14)
Note: Please visit our
website for optional
accessories.
+
-
CAUTION: 1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not
provide adequate ventilation for the electronics or proper support for the front glass
panel. This LCD television product is designed for a maximum tilting angle of 45
degrees from vertical.
2. This stand for use only with Hitachi 37HLX99. Use with other
apparatus is capable of resulting in instability causing possible injury.
쐃 Remote Control Unit CLU-3861WL 쐄 Two IR Blaster cables (P# EY01641).
(Part No. HL02069). 쐂 Power Swivel Cable (P# EW08432).
쐇 Two “AA” size, 1.5V batteries (P# FQ00021). 쐆 1 Ferrite Core (P#2169513).
쐋 Power Cord (P# EV01841).
쐏 Table Top Stand (P# QJ02673 ).
쐄
쐃
쐋
쐆
쐇
쐂
쐏
REMOTE CONTROL BATTERY INSTALLATION
AND REPLACEMENT
1. Open the battery cover of the remote control by
pushing down and sliding the back cover off.
2. Insert two new “AA” size batteries for the
remote control.
When replacing old batteries, push them
towards the springs and lift them out.
3. Match the batteries to the (+) and (-) marks in the battery compartment.
4. Replace the cover.
CAUTION: Do not insert batteries with the ‘+’and ‘-’ polarities reversed as this may cause the
batteries to swell or rupture resulting in leakage.
BOTTOM VIEW
(Remote Control)
Press down and slide back to remove.
To Next Page
Loading...
Need help?
General