EasyManuals Logo
Home>Hitachi>Projector>CP-D10

Hitachi CP-D10 Operating Guide

Hitachi CP-D10
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #104 background imageLoading...
Page #104 background image
6
WARNING Ź,QVWDOOWKHSURMHFWRULQDVWDEOHKRUL]RQWDOSRVLWLRQ
Ź
3ODFHWKHSURMHFWRULQDFRROSODFHDQGHQVXUHWKDWWKHUHLVVXI¿FLHQWYHQWLODWLRQ'RQRW
place the projector where the air from an air conditioner or similar unit will blow on it directly.
Ź'RQRWSODFHWKHSURMHFWRUDQ\SODFHZKHUHLWPD\JHWZHW
Ź
8VHRQO\WKHPRXQWLQJDFFHVVRULHVWKHPDQXIDFWXUHUVSHFL¿HGDQGOHDYHLQVWDOOLQJ
and removing the projector with the mounting accessories to the service personnel.
Ź5HDGDQGNHHSWKHXVHUVPDQXDORIWKHPRXQWLQJDFFHVVRULHVXVHG
CAUTION Ź$YRLGSODFLQJWKHSURMHFWRULQVPRN\KXPLGRUGXVW\SODFH
Ź
Position the projector to prevent light from directly hitting the projector’s remote sensor.
Arrangement
<CP-D10>
Refer to the illustrations and tables below to determine screen size and projection distance.
The values shown in the table are calculated for a full size screen: 1024 x 768
a Screen size (diagonal)
b Projection distance (±8%) c1 , c2 Screen height
The screen position may shift after installation if the projector is suspended from the
FHLOLQJRURWKHUORFDWLRQGXHWRWKHÀH[LELOLW\RIWKHSODVWLFSURMHFWRUERG\,IUHDGMXVWPHQW
is necessary, consult with your dealer or service personnel.
The projected image position and/or focus may change during warm-up (approx. 30
minutes after the lamp is turned on) or when the ambient conditions change. Readjust
the image position and/or focus as necessary.
6LQFHWKHSURMHFWRUIHDWXUHVDQXOWUDVKRUWWKURZEHDZDUHWKDWLWLVUHTXLUHGWRVHOHFWD
screen carefully to have better performance.
-
A soft screen such as a pull-down screen may cause serious distortion of a projected image.
A hard screen such as a board screen is recommended for use with this projector.
- A high-gain screen such as a bead screen that has narrow viewing angle is not suitable
for this projector. A low-gain screen (around 1.0) such as a matte screen that has wide
viewing angle is recommended for use with this projector.
-
A screen with a weave pattern may cause moiré on the projected image, which is not a failure
of the projector. A screen that has less moiré effects is recommended for use with this projector.

The projector may make a rattling sound when tilted, moved or shaken,
VLQFHDÀDSWRFRQWUROWKHDLUÀRZLQVLGHRIWKHSURMHFWRUKDVPRYHG%HDZDUHWKDW
this is not a failure or malfunction.
NOTE
Screen size
(diagonal)
b
Projection distance
c1
Screen height
c2
Screen height
type(inch)
m m inch m inch m inch
60 1.5 0.683 27 0.279 11 1.193 47
70 1.8 0.805 32 0.314 12 1.381 54
80 2.0 0.927 36 0.350 14 1.569 62
90 2.3 1.049 41 0.385 15 1.757 69
100 2.5 1.170 46 0.421 17 1.945 77
a
2QDKRUL]RQWDOVXUIDFH
Suspended from the ceiling
a
c2
c1
b
a
c2
c1
b
.HHSDVSDFHRIFPRUPRUHEHWZHHQWKHVLGHVRIWKH
projector and other objects such as walls. Do not place or
attach anything that would block the lens or vent holes.

)RUWKHFDVHRILQVWDOODWLRQLQDVSHFLDOVWDWHVXFKDV
FHLOLQJPRXQWWKHVSHFL¿HGPRXQWLQJDFFHVVRULHV
(
17DQGVHUYLFHPD\EHUHTXLUHG%HIRUHLQVWDOOLQJWKH
projector, consult your dealer about your installation.

Other manuals for Hitachi CP-D10

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hitachi CP-D10 and is the answer not in the manual?

Hitachi CP-D10 Specifications

General IconGeneral
BrandHitachi
ModelCP-D10
CategoryProjector
LanguageEnglish

Related product manuals