Hitachi RAS-24PPAG User Manual

– 25 –
ENGLISH
INFO FUNCTION
O By pressing (INFO) button, temperature around remote controller and monthly power consumption will
be displayed on the remote controller.
O After changing the batteries, direct the remote controller towards the indoor unit and press (INFO)
button.
Current calendar and clock will be transmitted from indoor unit.
O In order to receive information from indoor unit, the distance between remote controller and receiver of indoor
units is within 2 meters.
Q To check temperature around remote controller
Q Current calendar and clock can be retrieved
from indoor unit
Q To check monthly power consumption
Press (INFO) button.
Temperature will be displayed for 10 seconds.
Direct the remote controller towards the receiver of indoor unit
(within 2 meters in front of indoor unit) and press
(INFO)
button. Wait for 2 seconds for signal transmission.
Once received the current calendar and clock, check whether they
are correct or not by pressing
(CLOCK) button.
O If there is no power supply to indoor unit or calendar and clock
have not been set, INFO function cannot be used for sending or
receiving information.
Direct the remote controller towards the receiver of indoor unit
(within 2 meters in front of indoor unit) and press
(INFO)
button. Wait for 2 seconds for signal transmission.
While temperature around remote controller is displayed, press
(INFO) button repeatedly. The display will show as below:
this month power consumption amount for heating
last month
power consumption amount for heating
this month power
consumption amount for cooling
last month power consumption
amount for cooling
temperature around remote controller this
month power consumption amount for heating ...... cyclically.
O If indication is not given, bring remote controller closer to the
receiver of the indoor unit.
O Indicated value shall be regarded as a guide only.
1
NOTE
O In case failure occurs to the air conditioner, by pressing (INFO) button, an error code will be
displayed.
Direct the remote controller towards the receiver of indoor unit (within 2 meters in front of indoor unit)
and press
(INFO) button. Wait for 2 seconds for signal transmission.
An error code will be displayed.
Call service center and inform the error code.

Hitachi RAS-24PPAG Specifications

General

Brand	Hitachi
Model	RAS-24PPAG
Category	Remote Control
Language	English