3 ELECTRICAL DATA
3.2.1 Considerations
Key words:
• U: Power supply.
• PH: Phase.
• IPT: Total input power.
• STC: Starting current: Less than maximum current.
• RNC: Running current.
• MC: Maximum current.
? NOTE
• Heating conditions: Inlet/outlet water temperature: 30/35 ºC ; Outdoor ambient temperature (DB/WB): 7/6 ºC
• The compressor data shown in the tables below are based on a combined capacity of 100% of the power supplied.
• The “Maximum current” shown in the above table is the maximum total unit running current at the following conditions:
- Supply voltage: 90% of the rated voltage.
- Unit capacity: 100% at maximum operating conditions.
• The power supply cables must be sized to cover this maximum current value.
• Specications in these tables are subject to change without notice in order that HITACHI may bring the latest innovations to their customers.
• Please refer to the general information, cautions and notes regarding protective devices (CB, ELB) throughout the “6 ELECTRICAL AND CONTROL
SETTINGS” chapter.
ELECTRICAL DATA
PMML0510 rev.1 - 10/2019
14
To Next Page
Need help?
General