Menu Contents
Level 1 Level 2 Level 3 Level 4 Level 5 Level 6
Hydraulic Sep. Status
Energy Conguration
Smart Function
Space Functions
Heating Auto On/Off
Auto Heat/Cool
DHW
Circuit pump
Recirculation timer
DHW Boost
Emergency Operation
I/O and Sensors
Inputs
Outputs
Auxiliary sensors
Controller Settings
Controller Options
Room Names
Date and Time
Menu Contents
Level 1 Level 2 Level 3 Level 4 Level 5 Level 6
Adjust Date and Time
European Summer Time
UTC Zone
Screen settings
Language selection
Commissioning
Air purge procedure
Start Air purge
Unit test run
Start test run
Screed drying
Start Screed Drying
About
System Information
Contact Information
Factory Reset
Return to user mode
Installer mode
Icon means that this menu is available only for installer, a special user with higher access privileges to congure the system. In
order to access the controller as Installer, “OK” and “ ” buttons must be pressed for 3 seconds.
OK +
After that, the “Enter password” message is displayed.
The login password for the Installer is:
Right , Down , Left , Right
Press “OK” to conrm the password.
If the correct access code is entered, the installer mode icon appears on the notications bar (bottom line).
Installer mode icon
After 30 minutes of inactivity, it is necessary to repeat the log in process. To exit the Installer mode and return to the unit menu, hold
down the “ ” button for 3 seconds or go to the “Return to user mode” on the main menu.
? NOTE
The following chapters explain the special settings the Installer can edit. It is important to understand that the Installer can also perform all the actions
available for the typical user.
UNIT CONTROLLER
PMML0510 rev.1 - 10/2019
74
To Next Page
Loading...
Need help?
General