194
uuOperating the Switches Around the Steering WheeluWipers and Washers
Wipers and Washers
The windscreen wipers and washers can be
used when the power mode is in ON.
■
MIST
The wipers run at high speed until you release
the lever.
■
Wiper switch (OFF, AUTO, LO, HI)
Move the lever up or down to change the
wiper settings.
■
Washer
Sprays while you pull the lever towards you.
When you release the lever for more than one
second, the spray stops, the wipers sweep two
or three more times to clear the windscreen,
then stop.
■
Windscreen Wipers/Washers
Do not use the wipers when the windscreen is dry.
The windscreen will get scratched, or the rubber
blades will get damaged.
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
The wiper motor may stop motor operation
temporarily to prevent an overload. Wiper operation
will return to normal within a few minutes.
In cold weather, the blades may freeze to the
windscreen.
Operating the wipers in this condition may damage
the wipers. Use the demister to warm the
windscreen, then turn the wipers on.
a MIST
b OFF
c AUTO
d LO: Low speed wipe
e HI: High speed wipe
f
Washer
23 CIVIC TYPE R JSS (KE KG)-32T406000_01.book 194 ページ ２０２２年７月１１日 月曜日 午前７時２０分
To Next Page
Loading...
Need help?
General
