28 Basic Operation & Riding
Starting & Stopping the Engine
If the engine fails to start after repeated
attempts, it may be flooded with excess fuel.
To clear a flooded engine:
1.Open the throttle fully.
2.While pushing the engine stop button, press
the start button for 5 seconds.
3.Release the engine stop button.
4.Follow the normal engine starting procedure
(page 27).
Your motorcycle’s banking (lean angle) sensor
system is designed to automatically stop the
engine and fuel pump if the motorcycle is
overturned.
Before restarting the engine, you must turn the
ignition switch to the OFF position and then
back to (ON). The engine will not restart
until you perform this procedure.
To stop the engine, shift into neutral, and turn
the ignition switch to the OFF position.
Flooded Engine Bank Angle Sensor Ignition Cut-off
System
How to Stop the Engine
To Next Page
Loading...
Need help?
General
