18 Basic Operating Instructions
Starting & Stopping the Engine
Warm Engine Starting
1. Shift the transmission into neutral.
2. Pull the clutch lever all the way in, and depress
the start button. (Do not open the throttle.)
Starting the engine excessively charged with fuel
by throttle blipping or other reasons
1. Shift the transmission into neutral.
2. With the throttle fully opened, pull the clutch
lever all the way in, and depress the start button
for 5 seconds to discharge excessive fuel from
the engine.
3. Pull the clutch lever all the way in, and depress
the start button. (Do not open the throttle.)
Snapping the throttle or fast idling for more than
about 5 minutes may cause exhaust pipe and
muffler discolorations.
When starting the engine, the MIL (amber) will
stay on for 2 seconds, then go off. And then the
mode indicator (blue) indicates the current engine
mode for 0.8 seconds, then goes off. If the MIL/
mode indicator (1) does not come on or go off
when it should, have your dealer check it for
problems.
Normal Engine Stop
1. Shift the transmission into neutral.
2. Push and hold the engine stop button (1) until
the engine stops completely.
Emergency Engine Stop
To stop the engine in an emergency, push and hold
the engine stop button.
(1) MIL (amber) / mode indicator (blue)
(1)
How to Stop the Engine
(1) engine stop button
(1)
To Next Page
Loading...
Need help?
General
