EasyManuals Logo

Honda CRF250R 2020 User Manual

Honda CRF250R 2020
179 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #57 background imageLoading...
Page #57 background image
52 Servicing Your Honda
Engine Oil
1. Run the engine at idle for 3 minutes, then shut
it off.
2. Wait 3 minutes after shutting off the engine to
allow the oil to properly distribute itself in the
engine.
3. Support the CRF in an upright position on a
level surface.
4. Check that the oil level is between the upper
(1) and lower (2) level marks in the oil level
inspection window (3).
If the oil is at or near the upper level mark,
you do not have to add oil.
If the oil is below or near the lower level
mark, remove the oil fill cap (4) and add the
recommended oil until it reaches the upper
level mark. (Do not overfill.)
5. Check that the O-ring (5) is in good condition
and replace it if necessary.
6. Reinstall the engine oil fill cap (4).
7. Check for oil leaks.
1. Remove the engine guard A bolts/washers (1),
B bolt/washer (2) and engine guard (3).
2. Run the engine at idle for 3 minutes, then shut
it off.
3. Support the CRF in an upright position on a
level surface.
Checking & Adding Oil
(1) upper level mark
(2) lower level mark
(3) inspection window
(4) engine oil fill cap
(1)
(2)
(3)
(4)
(4) engine oil fill cap
(5) O-ring
(4)(5)
Changing Engine Oil & Filter
(1) engine guard A bolts/washers
(2) engine guard B bolt/washer
(3) engine guard
(1)
(2)
(3)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honda CRF250R 2020 and is the answer not in the manual?

Honda CRF250R 2020 Specifications

General IconGeneral
Engine Type249cc liquid-cooled single-cylinder four-stroke
Bore x Stroke79.0mm x 50.9mm
Compression Ratio13.9:1
IgnitionFull transistorized ignition
Front BrakeSingle 260mm disc with twin-piston caliper
Front Tire80/100-21
Rear Tire100/90-19
Trail4.6 inches
Wheelbase58.3 inches
Seat Height37.8 inches
Fuel Capacity1.6 gallons
Ground Clearance13.2 inches
Valve TrainUnicam, 4-valve
InductionProgrammed Fuel Injection (PGM-FI)
Transmission5-speed
Final Drive#520 chain
Front Suspension49mm inverted Showa coil-spring fork with rebound and compression damping adjustability; 12.2 inches travel
Rear SuspensionShowa® Pro-Link® system with rebound and compression damping adjustability; 12.4 inches travel
Rear BrakeSingle 240mm disc
Rake27.2°

Related product manuals