EasyManuals Logo

Honda EC6000 User Manual

Honda EC6000
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
19
MAINTENANCE
2. Paper element [4]: tap the element lightly several times
on a hard surface to get rid of any loose dirt, or blow
through with compressed air from the inside towards the
outside. Never brush the element, as this causes
impurities to penetrate the fibres. Replace the paper
element if it is very dirty.
3. Foam element
[5]:
- wash the element in a solution of warm water
containing non-foaming household detergent, rinse it
and allow it to dry thoroughly,
or
- clean it in a non-flammable solvent and allow it to dry
thoroughly.
- Dip the element in clean engine oil, then squeeze it to
remove excess oil. If too much oil is left in the foam, the
engine will smoke the next few times it is started.
4. Refit the ring seal [6], the air cleaner elements [4] and [5],
the wing nut [3], and the cover [2] and tighten the wing
nut [1] fully.
CAUTION :
Do not use the generating set without its air cleaner, as this can damage the engine.
EC4000 / EC6000 / ECT6500
1. Remove the wing nut [1] and the air cleaner cover [2].
Remove the wing nut [5], remove the elements [3] and [4]
and separate them. Check carefully that the two elements
are not torn or blocked; replace them if they are
damaged.
2. Paper element
[3]: tap the element lightly several times
on a hard surface to get rid of any loose dirt, or blow
through with compressed air from the inside towards the
outside. Never brush the element, as this causes
impurities to penetrate the fibres. Replace the paper
element if it is very dirty.
3. Foam element
[4]:
- wash the element in a solution of warm water
containing non-foaming household detergent, rinse it
and allow it to dry thoroughly, or clean it in a non-
flammable solvent and allow it to dry thoroughly.
- Dip the element in clean engine oil, then squeeze it to
remove excess oil. If too much oil is left in the foam, the
engine will smoke the next few times it is started.
4. Refit the air cleaner element [3] and [4], the wing nut [5] and the cover [2], and tighten the
wing nut [1] fully.
CAUTION :
Do not use the generating set without its air cleaner, as this can damage the engine.
[2]
[1]
[4]
[5]
[6]
[3]
[1]
[2]
[3]
[4]
[5]
OMec_GB.book Page 19 Vendredi, 21. octobre 2005 3:05 15

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honda EC6000 and is the answer not in the manual?

Honda EC6000 Specifications

General IconGeneral
BrandHonda
ModelEC6000
CategoryInverter
LanguageEnglish

Related product manuals