3. CONTROLS
RDTO-STOP LEVER
I
The ROTO-STOP lever operates the blade brake/clutch mechanism. It is used
to start and stop the blade.
To put the blade into operation, press the button on top of the ROTO-STOP
lever, then push the lever forward and hold it against the handlebar.
Releasing the ROTO-STOP lever will stop the blade
Operate the ROTO-STOP lever with a quick and complete motion, so the blade
drive is always either fully engaged or stopped. This will help to prevent stalling
the engine, and it will also extend the service life of the ROT&TOP mechanism.
IMPORTANT NOTICE
1 If you move the ROTO-STDP lever sSowly or partially,
the blade brake/clutch mechanism will wear out prematurely.
NOTE: Always release the ROTO-STOP lever before starting the engine If the
blade drive is engaged, extra effort will be required to operate the starter.
ROTO-STOP LEVER
4
11
To Next Page
Loading...
Need help?
General
