Honda Marine BF15D User Manual

52
Trim
(T type)
OPERATION
Motor Angle (Crusing)
O.K.
CORRECT
GIVES MAXIMUM PERFORMANCE
Excessive tilt angle during operation
can cause propeller ventilation,
overheating, and water pump
damage.
Excessive tilt angle during operation
can cause propeller ventilation,
overheating, and water pump
damage.
Use the power tilt switch to trim the
outboard motor for the best
performance and stability.
Press the UP or DN (down) side of
the switch to adjust the angle of the
outboard motor.
It is necessary to trim the angle of the
outboard motor to compensate for
changes in boat load, weight
distribution, water conditions, or
propeller selection.
Under normal conditions, the boat
will perform best when the
antiventilation plate is level with the
water.
03/03/24 18:12:27 31ZY0600_053

Honda Marine BF15D Specifications

General

Displacement	350 cc (21.4 cubic inches)
HP Rating	15 HP
Fuel Delivery	Carburetor
Ignition System	Digital CDI
Starting System	Manual or Electric
Gear Ratio	2.08:1
Trim Positions	5
Cooling System	Water Cooled
Lubrication	Wet Sump
Recommended Fuel	Unleaded Gasoline (86 Octane)
Propeller	3-Blade Aluminum
Power Tilt	No
Trim Method	Manual
Engine Type	4-stroke
Full Throttle RPM Range	5000 - 6000 rpm
Exhaust	Through propeller hub
Oil Capacity	1.1 L
Fuel Tank Capacity	12 L
Steering	Tiller
Shaft Length	15 inches / 20 inches
Engine Oil Capacity	1.1 L
Bore and Stroke	59 mm x 64 mm (2.32 inches x 2.52 inches)