English | 13
Main Menu Sub-menu 1 Sub-menu 2 Explanation
Advanced
Wire ID Change the perimeter wire ID when possible
interferences are nearby.
Sensor setting/
Lawn condition
Select between Low (uneven ground), Normal and High
(slippery ground). Mower bump sensor will become more
or less sensitive depending on lawn condition selected.
Remap Deletes the current map of the garden.
Factory Reset Reset the mower to factory settings will delete all
personal settings (not PIN).
After a factory reset, the mower will need to remap the
gardens.
Garden overview Displays the number of mapped gardens, their size, their
wire ID and the date of the last time the garden was cut.
Delete garden Delete one specific garden map or select to delete all
maps at once.
Name mower Change the name shown in the display. Only letters of
the Latin alphabet are possible. The number of letters is
limited. This function is not available in every language.
In some languages (e.g. Czech or Polish) a name change
doesn’t have effect on display due to specific grammar
requests.
Tools
Level check Information about the ground angle of the mower. If the
mower is in the docking station and the dot on the display
is not within the indicated circle, the docking station must
be repositioned in a new, more level location.
Wire signal Detects the wire signal received from the perimeter wire,
indicating its strength (for Service Agent).
The mower will not receive any wire signal while in the
docking station.
Troubleshooting
Problem Possible Cause Corrective Action
The LED on the
docking station
flashes
The perimeter wire is
interrupted, too long or too
short. Wire not connected
and mower not in the docking
station.
Check that the perimeter wire is not interrupted and is
between 20 and 250 meters in length. Then switch power
supply off and then on again.
Follow instructions in Installation Guide on installing the
mower.
Excessive vibrations/
noise
Blade bolt loose Tighten blade bolt to torque of 2.5 Nm.
Cutting blade damaged/bent Replace cutting blade (see figure K).
Mower not docking
reliably
Perimeter wire not properly
layed out around docking
station
Follow instructions in Installation Guide on layout of
perimeter wire.
Perimeter wire close to a
source of interference
Remove any excess (e.g. coiled up) perimeter wire
around the docking station.
Change perimeter wire ID in the menu.
To Next Page
Loading...
Need help?
General
