Honda PCX 150 User Manual

Adding Engine Oil
If the engine oil is below or near the lower
level mark, add the recommended engine oil.
2 P. 75, 2 P. 143
1. Remove the oil fill cap/dipstick. Add the
recommended oil until it reaches the
upper level mark.
u Place your scooter on its centre stand
on a firm, level surface when checking
the oil level.
u Do not overfill above the upper level
mark.
u Make sure no foreign objects enter the
oil filler opening.
u Wipe up any spills immediately.
2. Securely reinstall the oil fill cap/dipstick.
NOTICE
Overfilling with oil or operating with insufficient
oil can cause damage to your engine. Do not mix
different brands and grades of oil.
Changing the oil and cleaning the strainer
screen requires special tools. We recommend
that you have your scooter serviced by your
dealer.
Change the engine oil with the Idling Stop
switch at IDLING.
1. If the engine is cold, idle the engine for 3
to 5 minutes.
2. Turn the ignition switch to the
(Off)
position and wait for 2 to 3 minutes.
20180912083000_32K97Q000_eng_BOOK Page 94 Wednesday, September 12 2018 08:36:26 JST
Engine Oil u Adding Engine Oil
For the recommended oil and oil selection
guidelines, see “Maintenance Fundamentals.”
2 P. 75
Changing Engine Oil, Cleaning
Strainer Screen
Maintenance
Continued
89

Honda PCX 150 Specifications

General

Displacement	149cc
Bore x Stroke	57.3mm x 57.9mm
Compression Ratio	10.6:1
Fuel System	PGM-FI electronic fuel injection
Ignition	Full transistorized ignition
Transmission	Automatic V-Matic
Front Suspension	31mm telescopic fork
Front Brake	Hydraulic disc
Rear Brake	Mechanical drum
Front Tire	100/80-14
Rear Tire	120/70-14
Wheelbase	51.8 inches
Seat Height	30.1 inches
Fuel Capacity	2.1 gallons
Starter	Electric
Front Brake Disc Size	220mm
Rear Brake Drum Size	130mm
Rear Suspension	Twin shock