Removing & Installing Body Components
Battery
#
Removal
Make sure the ignition switch is in the
(Off) position.
1.
Remove the battery cover. 2 P. 83
2.
Unhook the rubber strap.
3.
Disconnect the negative - terminal from
the battery.
4.
Disconnect the positive + terminal from the
battery.
5.
Remove the battery taking care not to drop
the terminal nuts.
#
Installation
Install the parts in the reverse order of removal.
Always connect the positive + terminal first.
Make sure that bolts and nuts are tight.
Make sure the clock information is correct after
the battery is reconnected. 2 P. 23
AG, CO type
The anti-theft alarm system will be deactivated
if the battery is disconnected. The system will
remain off when the battery is reconnected.
For proper handling of the battery, see
“Maintenance Fundamentals.” 2 P. 73
“Battery Goes Dead.” 2 P. 123
20180912083000_32K97Q000_eng_BOOK Page 87 Wednesday, September 12 2018 08:36:26 JST
Maintenance
82
Positive terminal Rubber strap
Battery
Negative terminal
To Next Page
Loading...
Need help?
General
