Additional Features: Bolt-Down KitAdditional Features: Bolt-Down Kit
Additional Features: Bolt-Down KitAdditional Features: Bolt-Down Kit
Additional Features: Bolt-Down Kit
Installation ProcedureInstallation Procedure
Installation ProcedureInstallation Procedure
Installation Procedure
1. Choose a mounting location that is easily
accessible from both above and below.
2. Carefully position the template on the location
that you want to mount the safe.
3. Create the guide marks by pressing a sharp
tool through the circles at the four corners of
the template and into the mounting location.
4. Drill a hole (the diameter of the break-off bolt
shaft) through each guide mark.
5. Before attaching the safe, you should check
carefully that the 4 holes you have drilled
match up precisely with the holes that have
been pre-drilled in the bottom of the safe.
Note: On certain models, It may be necessary
to remove the rubber foot pads that are
screwed into the bolt-down holes at the
factory.
6. Once you have confirmed that the holes are
aligned and in the location you desire, install
the break-off bolts and washers from
underneath the mounting location (through
the furniture or shelf), and into the pre-drilled
holes in the safe.
7. Turn bolts until the screw heads break off.
Home and Office Security Safes
Models 2054D (only)Models 2054D (only)
Models 2054D (only)Models 2054D (only)
Models 2054D (only)
77
77
7
Important: Important:
Important: Important:
Important:
DON’T DRILL SAFEDON’T DRILL SAFE
DON’T DRILL SAFEDON’T DRILL SAFE
DON’T DRILL SAFE
Do not drill into the feet, bottom or
any other part of safe! Doing so will
ELIMINATE THE FIRE PROTECTIONELIMINATE THE FIRE PROTECTION
ELIMINATE THE FIRE PROTECTIONELIMINATE THE FIRE PROTECTION
ELIMINATE THE FIRE PROTECTION
that has been designed into your safe
and invalidate all stated warranties.
Installing Your SafeInstalling Your Safe
Installing Your SafeInstalling Your Safe
Installing Your Safe
Certain models include a Bolt-Down kit with break-off bolts and a mounting
template for permanent mounting to a flat surface. Once the safe is installed
using the break-off bolts, it is permanent and cannot be easily removed.
Tools RequiredTools Required
Tools RequiredTools Required
Tools Required
4 – Break-off Bolts (Supplied)
4 – Washers(Supplied)
1 – Mounting Template (Supplied)
1 – Drill
1 – Screwdriver
66
66
6
Additional Features: Bolt-Down KitAdditional Features: Bolt-Down Kit
Additional Features: Bolt-Down KitAdditional Features: Bolt-Down Kit
Additional Features: Bolt-Down Kit
Models 2054D (only)Models 2054D (only)
Models 2054D (only)Models 2054D (only)
Models 2054D (only)
Important: Important:
Important: Important:
Important:
SECURING TO FLOORSECURING TO FLOOR
SECURING TO FLOORSECURING TO FLOOR
SECURING TO FLOOR
Many consumers prefer to bolt their safe to the floor to
increase protection from theft and resistance to tipping. If
your safe was manufactured with bolt down holes pre-
drilled in the floor of the safe, bolting your safe to the
floor may provide additional theft deterrence.
If you have
ANY QUESTIONSANY QUESTIONS
ANY QUESTIONSANY QUESTIONS
ANY QUESTIONS
about how to accomplish
this, or are uncomfortable using the tools necessary to
complete this project, please check with your local retailer,
home center, or independent contractor.
To Next Page
Loading...
Need help?
General