ADEMCO 6152RF Keypad / Transceiver –
User Guide
Fixed Addressable Keypad/Transceivers for use with Honeywell
Control Panels; incorporates normally-open relay output with the
functions of a 16 zone RF Receiver and a 5800 Transmitter module.
= READY to Arm
= NOT READY to Arm
= System ARMED
= System NOT ARMED
Programmable Function Keys*
Arming Keys
6152RF: Fixed Word Display
2-Digit Zone Identifier
The ‘21’ digits are used for specific
trouble indications. Refer to the
control panel instructions for details.
ALARM
FIRE
AWAY
BYPASS
STAY
CHECK
INSTANT CANCELED
NO NIGHT AC
NOT READY
CHIME BAT
TESTPHONE
6152RF-KEYPAD-LBLD-UG-07-19-13_1
Sounder
*
The Function Keys can be
programmed for special functions
or panic alarm activations. See
the Function Keys section and
check with the system installer
for more information.
SETTINGS KEY FUNCTION
The Settings key provides an easy method to test the keypad display.
For Display Test mode: Press and hold
for 2 seconds.
FUNCTION KEYS
The Function keys may be programmed by the installer
for special functions or alarm activations. Key pairs
may also be programmed for alarm activations.
To activate the Function keys, press and hold the key
for at least 2 seconds; key pairs are activated
immediately.
COMMERCIAL STAY MODES
For commercial controls, if Stay Mode 2 is programmed, refer to the control’s
manuals and the table below for Stay mode arming.
+ 1 = Stay Mode 1
+ 2 = Stay Mode 2
= Stay Mode 3 (both Stay 1 and Stay 2 modes)
Note: Not intended for use with the VISTA-128/250 Series.
Check with the system installer for more information.
A or
and
B or and
C or and
D
To Next Page
Need help?
General