Honeywell ADEMCO 6150V - User Manual

K0022UGV1 12/01 Rev. C
ADEMCO 6150V & 6160V
Voice Remote Keypad
USER GUIDE
This document provides Operating Instructions for your Keypad’s voice features. Refer to your
security system User Guide for all other security system functions and operating procedures.
Message Center
The ADEMCO 6150V/6160V Keypads feature a
voice message center that lets you record and
playback one message.
• The message can be up to 2.5-minutes long
• The message remains in the Keypad’s
memory until a new message is recorded.
• The volume control of the message is
adjustable.
• Refer to the procedures below when using the
Message Center functions.
1
OFF
4
MAX
7
INSTANT
READY
2
AWAY
5
TEST
8
CODE
0
3
STAY
6
BYPASS
9
CHIME
#
ARMED
READY
6160V-00-005-V1
MESSAGE
MIC
RECORD
VOLUME
PLAY
STATUS
VOICE
FUNCTION
VOLUME
KEY
VOICE
KEY
STATUS
KEY
FUNCTION
KEY
DOWN
VOLUME
PLAY KEY
AND
UP VOLUME
RECORD
KEY
SPEAKER
LCD
DISPLAY
MICROPHONE
LEDs
To record a message: Press [#] FUNCTION + [0] VOICE + [1] RECORD keys.
The red MESSAGE indicator will light, indicating record in progress.
Note: A message cannot be recorded during the Exit Delay period.
To end recording: Press [1] RECORD key.
The red MESSAGE LED will flash indicating a message waiting to be
played. After the message is played once the MESSAGE LED will go
out.
To play a message: Press [#] FUNCTION + [0] VOICE + [3] PLAY keys.
The recorded message plays and the red MESSAGE LED turns off. The
recorded message will remain in memory until a new message is
recorded.
To adjust the volume: Press [#] FUNCTION + [0] VOICE + [2] VOLUME keys,
then press the desired volume control key [3] ↑ (up) or [6] ↓ (down).
Note:
• Adjusting message volume also adjusts status volume. Volume
cannot be adjusted while playing a message.
• Each time you enter the command to adjust the volume, the word
“CHECK” will be heard to verify the current setting.
(Continued on Other Side)

Summary

Message Center

To record a message

Instructions for recording a voice message on the keypad.

To end recording

Procedure to stop voice message recording.

To play a message

How to playback recorded voice messages from the keypad.

To adjust the volume

Steps to change the volume for voice messages and status.

Chime and Status Features

Voice Chime On;Off

How to enable or disable voice chime for zone announcements.

Voice Status

Explains using the STATUS key to announce system status and faults.

To Announce Status

Procedure to announce current system status via voice.

To Announce Faults

How to announce faulted zones and their descriptions.

Honeywell ADEMCO 6150V Specifications

General

Brand	Honeywell
Model	ADEMCO 6150V
Category	Keypad
Language	English