EXCEL 100C INSTALLATION INSTRUCTIONS
EN1R-0144GE51 R1007 30
6.
Reattach the cover.
Setting the Port Selector Switch
IMPORTANT
You must properly set the port selector (left to the front port, see figure on page 30); e.g. after having operated an MMI via the
front port, the switch must be set back to its left position to reactivate a modem being connected to the rear terminals. If the
switch is set to "front port“, the rear terminals are deactivated, and vice versa.
Front port Rear terminals
active active
REMOTE COMMUNICATIONS
For remote communications with up to three XBS Building Centrals, a modem or
ISDN* terminal adapter can be connected directly to the front serial port or the rear
terminals on the base of the Excel 100C (see graphics below).
NOTES:
Remote communication via modem or ISDN* terminal adapter requires
firmware version V2.03.01 or higher.
XBSi building supervisors are not supported for remote communication.
To Next Page
Loading...
Need help?
General
