POWER:
Press the cold switch (green) on the back of the unit to turn
ON the cold function. Press the Hot Switch (red) to turn on the
heating function. DO NOT turn on the hot function until the unit
has water inside the tanks. Please refer to INSTALLING YOUR
WATER COOLER FOR THE FIRST TIME section. Functions may
have a safety delay after turning them on.
WATER TAPS:
Press down the hot, room temperature or cold water taps to
dispense the desire water temperature. To use the hot water,
slide the safety lock to the left side and simultaneously press
down the tap.
DRAIN CAP:
Turn counterclockwise to remove the drain cap to drain the
water from the tanks. Turn clockwise to close the drain cap.
RESET BUTTON:
The reset button is automatically activated when the door is
closed. This will indicate the unit the water bottle has been
replaced and the indicator light will turn OFF.
• This appliance is not intended for use by persons
(including children or elderly) with reduced physical,
sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
• Never clean parts with ammable uids. The fume
can create a re hazard or explosion.
• Do not store or use gasoline or any other ammable vapors and liquids in the vicinity of
this or any other water dispenser. The fumes can create a re hazard or explosion.
• Keep this instructions handy for future reference.
To Next Page
Loading...
Need help?
General
